Dell Force10 S25-01-GE-24P Installing the S25P System - Page 20

Four-Post Rack-mounting with Threaded Rails, Installing the S25P

Get Dell Force10 S25-01-GE-24P PDF manuals and user guides View all Dell Force10 S25-01-GE-24P manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Four-Post Rack-mounting with Threaded Rails Ensure that there is adequate clearance surrounding the cabinet or rack to permit access and airflow. If you are installing two S25P switches side-by-side, position the two S25P chassis at least 5 inches (12.7 cm) apart to permit proper airflow. Follow the steps below to install a switch into a 4-post 19-inch equipment rack, using the attached front mounting brackets and the optional adjustable rear-mounting brackets. Step 1 Task Align the three screw holes of the adjustable rear mounting bracket with the three holes in the S25P chassis, and secure the mounting bracket with three screws. Figure 7 Four-Post Rack-mounting with Threaded Rails Stack ID AC1 XFP25 XFP26 AACla2rm 27 P28 S25-01-GE-24P 2 Insert the S25P into the rack, and secure the chassis to the front post with two screws. Then secure the chassis to the rear posts with two screws. Figure 8 Four-Post Rack-mounting with Threaded Rails . Stack ID AC1 XFP25 XFP26 AACla2rm 27 P28 S25-01-GE-24P 20 Installing the S25P

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
20
Installing the S25P
Four-Post Rack-mounting with Threaded Rails
Ensure that there is adequate clearance surrounding the cabinet or rack to permit access and airflow. If you
are installing two S25P switches side-by-side, position the two S25P chassis at least 5 inches (12.7 cm)
apart to permit proper airflow. Follow the steps below to install a switch into a 4-post 19-inch equipment
rack, using the attached front mounting brackets and the optional adjustable rear-mounting brackets.
Step
Task
1
Align the three screw holes of the adjustable rear mounting bracket with the three holes in the S25P chassis, and
secure the mounting bracket with three screws.
Figure 7
Four-Post Rack-mounting with Threaded Rails
2
Insert the S25P into the rack, and secure the chassis to the front post with two screws. Then secure the chassis to
the rear posts with two screws.
Figure 8
Four-Post Rack-mounting with Threaded Rails .