Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1199

Parameters policy-map-name Enter the name for the policy map in character format (16 characters maximum). Defaults No default behavior or values Command Modes CONFIGURATION Command History Version 8.2.1.0 Version 7.6.1.0 pre-Version 6.1.1.1 Policy name character limit increased from 16 to 32. Introduced on C-Series and S-Series Introduced on E-Series Usage Output policy map is used to assign traffic to different flows using QoS policy. This command enables Information the policy-map-output configuration mode (conf-policy-map-out). Related Commands service-queue policy-aggregate service-policy output Assign a class map and QoS policy to different queues. Allow an aggregate method of configuring per-port QoS via policy maps. Apply an output policy map to the selected interface. qos-policy-input c e s Create a QoS input policy on the router. Syntax qos-policy-input qos-policy-name [layer2] To remove an existing input QoS policy from the router, use no qos-policy-input qos-policy-name [layer2] command. Parameters qos-policy-name layer2 Enter your input QoS policy name in character format (32 character maximum). (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. Default: Layer 3 Defaults Layer 3 Command Modes CONFIGURATION Command History Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Policy name character limit increased from 16 to 32. Introduced on S-Series Introduced on C-Series E-Series Only: Expanded to add support for Layer 2 Usage Information Use this command to specify the name of the input QoS policy. Once input policy is specified, rate-police can be defined. This command enables the qos-policy-input configuration mode- (conf-qos-policy-in). Quality of Service (QoS) | 1199