Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 345

neighbor distribute-list c e s Distribute BGP information via an established prefix list. Syntax neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in | out} To delete a neighbor distribution list, use the no neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in | out} command. Parameters ip-address peer-group-name prefix-list-name in out Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to apply the distribute list filter to all routers in the peer group. Enter the name of an established prefix list. If the prefix list is not configured, the default is permit (to allow all routes). Enter the keyword in to distribute only inbound traffic. Enter the keyword out to distribute only outbound traffic. Defaults Not configured. Command Modes ROUTER BGP Usage Other BGP filtering commands include: neighbor filter-list, ip as-path access-list, and neighbor Information route-map. Related Commands ip as-path access-list neighbor filter-list neighbor route-map Configure IP AS-Path ACL. Assign a AS-PATH list to a neighbor or peer group. Assign a route map to a neighbor or peer group. Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series neighbor ebgp-multihop c e s Attempt and accept BGP connections to external peers on networks that are not directly connected. Syntax neighbor {ip-address | peer-group-name} ebgp-multihop [ttl] To disallow and disconnect connections, use the no neighbor {ip-address | peer-group-name} ebgp-multihop command. Parameters ip-address peer-group-name ttl Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group. (OPTIONAL) Enter the number of hops as the Time to Live (ttl) value. Range: 1 to 255. Default: 255 Defaults Disabled. Border Gateway Protocol IPv4 (BGPv4) | 345