Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 521

test-condition (comparing samples) test-condition message-text (deprecated) Collect multiple samples of a statistic and compare them using the specified comparator and hurdle value. Search for a stated value in the output of the designated show command or message type. test-condition message-text (deprecated) c e Configure a search for a stated value in the output of the designated show command or message type - syslog or other error messages, sent to the console, trap, or message logged locally. This applies only to messages logged by FTOS. Syntax test-condition message-text command string equal-to string string Parameters test-condition message-text command string equal-to string string Enter the keywords test-condition message-text command, and then for string, enter a show command in quotes. Range: 1-64 characters Enter the keywords equal-to string, and then for string, enter the text to search for in the show command designated above. Range: 1-64 characters Defaults none Command Modes conf-callhome-testlist-test Command History Version 8.2.1.0 Version 7.8.1.0 Deprecated. Introduced on C-Series and E-Series Usage Information In the following example: • The search string can be used for both "display xml" and normal "show command" output. • The search string is down. Note that the search target, in this example, is enclosed within double quotes. If either string contains spaces, it must be enclosed in quotes or it will be truncated at the first whitespace. The search string is compared against an entire text message, so a short string, such as the number zero, is likely to produce many unintended matches. Therefore, the search string should be as long as possible to guarantee as close a match as possible to the data that you want to match. However, the maximum length of a string is 64 characters. FTOS Service Agent | 521