Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 579
interface vlan
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 579 highlights
Related Commands interface range interface range macro (define) Configure a range of command (bulk configuration) Define a macro for an interface range (bulk configuration) interface vlan c e s Configure a VLAN. You can configure up to 4094 VLANs. Syntax interface vlan vlan-id To delete a VLAN, use the no interface vlan vlan-id command. Parameters vlan-id Enter a number as the VLAN Identifier. Range: 1 to 4094. Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1. Command Modes CONFIGURATION Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Figure 23-17. interface vlan Command Example FTOS(conf)#int vlan 3 FTOS(conf-if-vl-3)# Usage For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN) Information Commands. FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs are supported. See Chapter 9, Access Control Lists (ACL). Related Commands interface interface loopback interface null interface port-channel show vlan shutdown tagged untagged Configure a physical interface. Configure a loopback interface. Configure a null interface. Configure a port channel group. Display the current VLAN configuration on the switch. Disable/Enable the VLAN. Add a Layer 2 interface to a VLAN as a tagged interface. Add a Layer 2 interface to a VLAN as an untagged interface. Interfaces | 579