Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 983
show ipv6 neighbors Command Example, interface, fastEthernet, GigabitEthernet
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 983 highlights
cpu interface interface Enter the keyword cpu followed by either rp1 or rp2 (Route Processor 1 or 2), optionally followed by an IPv6 address to display the IPv6 neighbor entries stored on the designated RP. • For a Fast Ethernet interface, enter the keyword fastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number from 1 to 255. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by the VLAN ID. The range is from 1 to 4094. Defaults No default behavior or values Command Modes EXEC EXEC Privilege Example Figure 36-1. show ipv6 neighbors Command Example FTOS#show ipv6 neighbors IPv6 Address Expires(min) Hardware Address State Interface VLAN CPU fe80::201:e8ff:fe17:5bc6 1439 00:01:e8:17:5b:c6 STALE Gi 1/9 - CP fe80::201:e8ff:fe17:5bc7 1439 00:01:e8:17:5b:c7 STALE Gi 1/10 - CP fe80::201:e8ff:fe17:5bc8 1439 00:01:e8:17:5b:c8 STALE Gi 1/11 - CP fe80::201:e8ff:fe17:5caf 0.3 00:01:e8:17:5c:af REACH Po 1 - CP fe80::201:e8ff:fe17:5cb0 1439 00:01:e8:17:5c:b0 STALE Po 32 - CP fe80::201:e8ff:fe17:5cb1 1439 00:01:e8:17:5c:b1 STALE Po 255 - CP fe80::201:e8ff:fe17:5cae 1439 00:01:e8:17:5c:ae STALE Gi 1/3 Vl 100 CP fe80::201:e8ff:fe17:5cae 1439 00:01:e8:17:5c:ae STALE Gi 1/5 Vl 1000 CP fe80::201:e8ff:fe17:5cae 1439 00:01:e8:17:5c:ae STALE Gi 1/7 Vl 2000 CP FTOS# Neighbor Discovery Protocol (NDP) | 983