Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 648

www.dell.com | support.dell.com Parameters name ip-address Enter a text string to associate with one IP address. Enter an IP address, in dotted decimal format, to be mapped to the name. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series ip max-frag-count c e s Set the maximum number of fragments allowed in one packet for packet re-assembly. Syntax ip max-frag-count count To place no limit on the number of fragments allowed, enter no ip max-frag-count. Parameters count Enter a number for the number of fragments allowed for re-assembly. Range: 2 to 256 Defaults No limit is set on number of fragments allowed. Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series Usage To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for re-assembly low. Information ip mtu e Syntax Parameters Set the IP MTU (frame size) of the packet transmitted by the RPM for the line card interface. If the packet must be fragmented, FTOS sets the size of the fragmented packets to the size specified in this command. ip mtu value To return to the default IP MTU value, enter no ip mtu. value Enter the maximum MTU size if the IP packet is fragmented. Default: 1500 bytes Range: 576 to 9234 648 | IPv4 Routing