Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 403
neighbor filter-list
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
Command History neighbor filter-list neighbor route-map Assign a AS-PATH list to a neighbor or peer group. Assign a route map to a neighbor or peer group. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor filter-list c et s Configure a BGP filter based on the AS-PATH attribute. Syntax neighbor [ip-address | peer-group-name] filter-list aspath access-list-name [in | out] To delete a BGP filter, use the no neighbor [ip-address | peer-group-name] filter-list aspath access-list-name [in | out] command. Parameters ip-address peer-group-name access-list-name in out Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to apply the filter to all routers in the peer group. Enter the name of an established AS-PATH access list (up to 140 characters). If the AS-PATH access list is not configured, the default is permit (to allow routes). Enter the keyword in to filter inbound BGP routes. Enter the keyword out to filter outbound BGP routes. Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage Information Use the ip as-path access-list command syntax in the CONFIGURATION mode to enter the AS-PATH ACL mode and configure AS-PATH filters to deny or permit BGP routes based on information in their AS-PATH attribute. Related Commands ip as-path access-list Enter AS-PATH ACL mode and configure AS-PATH filters. Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series Border Gateway Protocol IPv4 (BGPv4) | 403