Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 249
monitor, order, fragments, established
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 249 highlights
log dscp order monitor fragments (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. Supported on Jumbo-enabled line cards only. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) Default: If the order keyword is not used, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, see the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Enter the keyword fragments to use ACLs to control packet fragments. Defaults Not configured Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History Version 8.3.1.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Version 6.5.10 Add DSCP value for ACL matching. Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Added support for non-contiguous mask and added the monitor option. Deprecated established keyword Expanded to include the optional QoS order priority for the ACL entry. Usage The monitor option is relevant in the context of the flow-based monitoring feature only. See Information Chapter 44, Port Monitoring. When you use the log option, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. The order option is relevant in the context of the Policy QoS feature only. The following applies: • The seq sequence-number is applicable only in an ACL group. • The order option works across ACL groups that have been applied on an interface via QoS policy framework. • The order option takes precedence over the seq sequence-number. • If sequence-number is not configured, then rules with the same order value are ordered according to their configuration order. • If the sequence-number is configured, then the sequence-number is used as a tie breaker for rules with the same order. Access Control Lists (ACL) | 249