Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 519
test-condition comparison to a value
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 519 highlights
Examples FTOS(conf-call-home-testlist-test)#test-condition cpu-1-min increase number ? Enter the boolean comparision value FTOS(conf-call-home-testlist-test)#test-condition cpu-1-min increase number 80 sample 5 FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min decrease ? Enter the boolean comparision value FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min decrease 10 In this next example, the configuration is to subtract the bit rate that was found in the second sample from the bit rate found in the first sample. If the difference is at least 10Mb, then any associated action list will be invoked. FTOS(conf-callhome-testlist-test)#test-condition interface-bit-rate ? input Input interface output Output interface FTOS(conf-callhome-testlist-test)#test-condition interface-bit-rate input ? Slot number FTOS(conf-callhome-testlist-test)#test-condition interface-bit-rate input 1 decrease ? Enter the boolean comparision value in mbits/sec FTOS(conf-callhome-testlist-test)#test-condition interface-bit-rate input 1 decrease 10 ? sample The time interval to check the condition FTOS(conf-callhome-testlist-test)#test-condition interface-bit-rate input 1 decrease 10 sample ? Enter the sample value (default = 2) FTOS(conf-callhome-testlist-test)#test-condition interface-bit-rate input 1 decrease 10 sample 2 Here are other examples of test-condition configuration statements. FTOS(conf-call-home-testlist-test)#test-condition interface-crc 1 decrease number 90 sample 5 FTOS(conf-call-home-testlist-test)#test-condition memory-free-percent no-change sample 4 Related Commands dampen test-limit test-condition (comparing samples) test-condition (comparison to a value) Set a delay before sampling for a test condition again after it has been matched. Set the number of times that the test list that should be executed. Collect multiple samples of a statistic and compare them using the specified comparator and hurdle value. Collect a sample of a designated statistic and then compare it to the designated number. test-condition (comparison to a value) c e Configure an action to collect a sample of a designated statistic and then use the designated Boolean comparator to compare it to the designated value. When this configuration is associated with an action list, a result outside of the acceptable limit will trigger the action list. Syntax test-condition statistic operator number {cpu | rpm-any} value FTOS Service Agent | 519