Dell OptiPlex 9020M Dell OptiPlex 9020M Owners Manual - Page 30

Installing the PS2 and Serial Connector Board, Removing the Heatsink, Installing the Heatsink

Get Dell OptiPlex 9020M PDF manuals and user guides View all Dell OptiPlex 9020M manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Installing the PS2 and Serial Connector Board 1. Place the PS2 and serial connector board into its slot. 2. Tighten the screws that secure the PS2 and serial connector board to the base panel. 3. Connect the cable to the PS2 and serial connector board. 4. Install the cover. 5. Follow the procedures in After Working Inside Your Computer. Removing the Heatsink 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a. cover b. processor fan module 3. Perform the following steps as shown in the illustration: a. Remove the screws that secure the heatsink to the system board [1]. b. Lift the heatsink away from the system board [2]. Installing the Heatsink 1. Place the heat sink on the system board. 2. Tighten the screws to secure the heatsink. 3. Install: a. processor fan module b. cover 4. Follow the procedures in After Working Inside Your Computer. 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
Installing the PS2 and Serial Connector Board
1.
Place the PS2 and serial connector board into its slot.
2.
Tighten the screws that secure the PS2 and serial connector board to the base panel.
3.
Connect the cable to the PS2 and serial connector board.
4.
Install the
cover
.
5.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Heatsink
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a.
cover
b.
processor fan module
3.
Perform the following steps as shown in the illustration:
a.
Remove the screws that secure the heatsink to the system board [1].
b.
Lift the heatsink away from the system board [2].
Installing the Heatsink
1.
Place the heat sink on the system board.
2.
Tighten the screws to secure the heatsink.
3.
Install:
a.
processor fan module
b.
cover
4.
Follow the procedures in
After Working Inside Your Computer
.
30