Dell PowerConnect 6248 User's Guide - Page 442
DAI ACL Configuration, Static Flag, Switching, Dynamic ARP Inspection, Configuration
View all Dell PowerConnect 6248 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 442 highlights
• Static Flag - Use this flag to determine whether the ARP packet needs validation using the DHCP snooping database, in case the ARP ACL rules do not match. If Enabled, then the ARP Packet will be validated by the ARP ACL Rules only. If Disabled, then the ARP Packet needs further validation by using the DHCP Snooping entries. The default is Disable. Configuring Dynamic ARP Inspection VLANs With CLI Commands For information about the CLI commands that perform this function, refer to the following chapter in the CLI Reference Guide: • Dynamic ARP Inspection Commands The following table summarizes the equivalent CLI commands for this feature. Table 7-60. Dynamic ARP Inspection VLAN Commands CLI Command ip arp inspection filter ip arp inspection vlan show ip arp inspection vlan Description Configures the ARP ACL to be used for a single VLAN or a range of VLANs to filter invalid ARP packets. Enables Dynamic ARP Inspection on a single VLAN or a range of VLANs. Displays the Dynamic ARP Inspection configuration on all the VLANs in the given VLAN range. DAI ACL Configuration Use the DAI ARP ACL Configuration page to add or remove DAI ARP ACLs. To display the DAI ARP ACL Configuration page, click Switching →Dynamic ARP Inspection →ACL Configuration in the navigation tree. Figure 7-109. Dynamic ARP Inspection ARP ACL Configuration The Dynamic ARP Inspection ARP ACL Configuration page contains the following field: 442 Configuring Switching Information