Dell PowerConnect 6248 User's Guide - Page 94
Software Download and Reboot, Software Download Through XModem
View all Dell PowerConnect 6248 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Software Download and Reboot Software Download Through XModem This section contains instructions for downloading switch software (system and boot images) using XModem, which is a data transfer protocol for updating back-up configuration files. NOTE: You must be connected to the serial console interface when doing this because xmodem download won't work elsewhere. To download a software image file using XModem: Specify the source file path to begin the transfer process. The following is an example of the information that appears: console#copy xmodem image Mode XMODEM Data Type Code Destination Filename image2 Management access will be blocked for the duration of the transfer Are you sure you want to start? (y/n) y console#boot system image2 Software Download Through TFTP Server This section contains instructions for downloading switch software (system and boot images) through a TFTP server. The TFTP server must be available on the network before downloading the software. The switch boots and runs when decompressing the system image from the flash memory area where a copy of the system image is stored. NOTE: You must run the boot system command to activate the newly downloaded image. On the next boot, the switch decompresses and runs the currently active system image unless chosen otherwise. To download an image through the TFTP server: 1. Ensure that an IP address is configured on and pings can be sent to a TFTP server. 2. Ensure that the file to be downloaded is saved on the TFTP server (the .stk file). 3. Enter the command show version to verify which software version is currently running on the switch. 94 Configuring Dell PowerConnect