Epson 2080 User Manual - Page 1
Epson 2080 - LQ B/W Dot-matrix Printer Manual
View all Epson 2080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Control Panel Buttons and Lights Font button Selects the font. See Chapter 5. Font lights Indicate which font is selected. Condensed button Turns on the condensed mode. Condensed light Lights up when the condensed mode is on. Pause button Stops printing temporarily, and resumes printing when pressed again. Pause light q On when the printer is paused. q Flashes when the printer is in the micro adjust mode. Paper Out light q On when no paper is loaded in the selected paper source or paper is not loaded correctly. q Flashes when paper has not been fully ejected or a paper jam has occurred. Tear Off/Bin button q Advances continuous paper to the tear-off position. q Feeds continuous paper backward from the tear-off position to the top-ofform position. q Selects a cut-sheet feeder bin when the cut-sheet feeder is installed. q Turns on the card mode to print on postcards and envelopes. See Chapter 3. LF/FF button q Feeds paper line by line. q Ejects a single sheet or advances continuous paper to the next top-of-form position when held down. Tear Off/Bin lights q f f when continuous paper is in the tear-off position. q o n when bin 1 of the optional cutsheet feeder is selected. q n o when bin 2 of the optional cutsheet feeder is selected. q n n when the printer is in the card mode. Operate button Turns the printer on and off. The printer is off when the top of this button is even with the button protectors. Load/Eject button q Loads a single sheet of paper. q Ejects a single sheet of paper if a sheet is loaded. q Loads continuous paper from the standby position. q Feeds continuous paper backward to the standby position. n = On f = Flashing o = Off Micro Adjust When you hold down the Pause button for three seconds, the printer enters the micro adjust mode. In this mode, you can press the D and U buttons to adjust the top-of-form or tear-off position. See Chapter 2.