Epson 2200 Service Manual - Page 124

EPSON Stylus PHOTO 2100/2200 An easy way to reinstall the Rear Housing is to insert the upper hooks of the Rear Housing into the Middle Housing, mount the Rear Housing using the two upper hooks as supports, and fit the cutouts of the Rear Housing into the lower hooks of the Lower Housing. Refer to Figure 4-8, "Hooks and Cutouts That Secure the Rear Housing". Revision B 4.2.1.3 Removing the Middle Housing 1. Remove the Upper Housing. (Refer to 4.2.1.1.) 2. Remove the two screws 3) C.B.P 3×14 (6±1kgf.cm), which secure the Middle Housing, from the Middle Housing. Middle Housing Front left side C.B.P 3×14 C.B.P 3×14 Front right side Figure 4-9. Screws That Secure the Middle Housing 3. Release the six hooks, which secure the left and right of the Middle Housing, from the Lower Housing, and while turning the Middle Housing rearward as viewed from the printer front, lift it to remove. By pushing the cutouts of the Lower Housing toward the printer inside one by one to disengage them from the hooks of the Middle Housing, you can release the hooks easily. Hooks Hooks DISASSEMBLY AND ASSEMBLY Figure 4-10. Hooks That Secure the Left and Right of the Middle Housing Disassembly 124