Epson 2200 Service Manual - Page 132
Removing the ASF Unit, Screws That Secure the Roll Paper Guide - stylus photo counter reset
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
EPSON Stylus PHOTO 2100/2200 " The Waste Ink Pads (Small) and the Waste Ink Pads located on the front right side and right side as viewed from the printer front are fixed by double-faced tape. When reapplying them, change the tape if its adhesive force is weak. Refer to Figure 4-21, "Removing the Waste Ink Pads". " When reapplying the Waste Ink Pad Fixing Films, change them if their adhesive force is weak. Refer to Figure 4-21, "Removing the Waste Ink Pads". " Fit the Ink Tube in the correct position of the Waste Ink Pads. Refer to Figure 4-22, "Specified Position of the Ink Tube". Ink Tube Revision B 4.2.4 Removing the ASF Unit 1. Remove the Rear Housing. (Refer to 4.2.1.2.) 2. Disconnect the Connector Cable of the ASF Sensor from the ASF Unit. 3. Remove the two screws 9) C.B.S (P4) 3×6 (6±1kgf.cm) and one screw 10) CR mount shaft that secure the Roll Paper Guide and ASF Unit. ASF Unit Connector Waste Ink Pads Figure 4-22. Specified Position of the Ink Tube A D JU S TM E N T R E Q U IR E D " When changing the Waste Ink Pads, make the following adjustment. • Protection counter reset " Refer to "Chapter 5 Adjustment" for the adjustment procedure. C.B.S(P4)3×6 Roll Paper Guide CR Mount Shaft C.B.S(P4)3×6 Figure 4-23. Screws That Secure the Roll Paper Guide 4. While lifting the Roll Paper Guide and ASF Unit slightly upward as viewed from the printer rear, slide them to the right to release the three hooks, which secure the Roll Paper Guide, from the Lower Frame, and remove the Roll Paper Guide and ASF Unit. Hooks Figure 4-24. Hooks That Secure the Roll Paper Guide DISASSEMBLY AND ASSEMBLY Disassembly 132