Epson 2200 Service Manual - Page 184
Removing the Cutter Motor, Disconnecting the Connector
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
EPSON Stylus PHOTO 2100/2200 Revision B 4.2.18.2 Removing the Cutter Motor 1. Remove the Cutter Housing. (Refer to Steps 1 and 2 in 4.2.18.1.) 2. Disconnect the Connector Cable (CN2) from the Driver Board and release it from the Harness Clamp. Harness Clamp Connector 3. Remove the two screws 16) C.P 2.5×3 (4±0.5kgf.cm) that secure the Cutter Motor, and while pulling and stretching the Timing Belt, remove the Pinion Gear of the Cutter Motor and remove the Cutter Motor from the Cutter Unit. Cutter Motor C.P 2.5×3 Driver Board Figure 4-143. Disconnecting the Connector Timing Belt Pinion Gear Figure 4-144. Screws That Secure the Cutter Motor DISASSEMBLY AND ASSEMBLY Disassembly 184
EPSON Stylus PHOTO 2100/2200
Revision B
DISASSEMBLY AND ASSEMBLY
Disassembly
184
4.2.18.2
Removing the Cutter Motor
1.
Remove the Cutter Housing. (Refer to Steps 1 and 2 in 4.2.18.1.)
2.
Disconnect the Connector Cable (CN2) from the Driver Board and release it from
the Harness Clamp.
Figure 4-143.
Disconnecting the Connector
3.
Remove the two screws 16) C.P 2.5
×
3 (4
±
0.5kgf.cm) that secure the Cutter Motor,
and while pulling and stretching the Timing Belt, remove the Pinion Gear of the
Cutter Motor and remove the Cutter Motor from the Cutter Unit.
Figure 4-144.
Screws That Secure the Cutter Motor
Harness Clamp
Connector
Driver Board
Cutter Motor
C.P 2.5
×
3
Pinion Gear
Timing Belt