Epson 2200 Service Manual - Page 154

EPSON Stylus PHOTO 2100/2200 Revision B 9. While pushing the Driven Pulley Holder to the right as seen from the printer front, loosen the Timing Belt and remove the Timing Belt from the Pinion Gear of the CR Motor. Driven Pulley Holder Timing Belt CR Motor Pinion Gear 13. Release the hook of the PG Change Lever and remove the PG Change Lever from the Carriage Guide Shaft A. C A U T IO N Handle the hook of the PG Change Lever fully carefully since it is easily damaged. Refer to Figure 4-76, "Removing the PG Change Lever". Figure 4-75. Removing the Timing Belt 10. Remove the Compression Spring 24.5 mounted on the Driven Pulley Holder. 11. Slide the Driven Pulley Holder to the right, as seen from the printer front, to remove the Driven Pulley Holder from the Frame. 12. Remove the PG Change Link from the PG Change Lever. (Refer to Steps 2 and 3 in 4.2.8.) C.B.S(P4) 3×6 PG Change Lever Hook Printer right side Figure 4-76. Removing the PG Change Lever DISASSEMBLY AND ASSEMBLY Disassembly 154