Epson 2200 Service Manual - Page 173
Removing the Torsion Spring 7.13, Screws That Secure the DE Unit, Removing the DE Unit
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
EPSON Stylus PHOTO 2100/2200 Revision B 8. Remove the Torsion Spring 7.13 that engages the DE Unit, ASF/Pump Motor and Under Frame. Circuit Board C.B.P 3×8 Hole in Under Frame 10. Slide the DE Unit rear side to the printer left side as seen from the printer rear, pull off the DE Unit upper side to the front, and remove the DE Unit together with the ASF/Pump Motor. DE Unit 2 Rear left side Torsion Spring 7.13 ASF/Pump Motor Front right side Figure 4-118. Removing the Torsion Spring 7.13 When reinstalling the Torsion Spring 7.13, bring the straight leg tip into contact with the ASF/Pump Motor, and hitch the other leg tip on the hole in the Under Frame. Refer to Figure 4-118, "Removing the Torsion Spring 7.13". 9. Remove the one screw 6) C.B.S 3×6 (9±1kgf.cm) and one screw 14) C.B.P 3×8 (6±1kgf.cm) that secure the DE Unit. Front right side C.B.P 3×8 C.B.S 3×6 1 Figure 4-120. Removing the DE Unit Figure 4-119. Screws That Secure the DE Unit DISASSEMBLY AND ASSEMBLY Disassembly 173