Epson 2200 Service Manual - Page 85

EPSON Stylus PHOTO 2100/2200 Revision B Occurrence Timing Phenomenon Detail The Paper feed switch The CD-R tray is fed toward the was pressed at the ASF but is ejected immediately. setting of the CD-R tray. (Only for Stylus PHOTO 2100) Table 3-5. Phenomenon-Based Paper Out Error Check Points Faulty Part/ Part Name CD-R tray Check Point Remedy 1. Check the HP detection position of the CD-R tray for paper dust 1. Remove paper dust and/or foreign matter from or foreign matter. the detection portion. CD-R tray HP detection position PW sensor 2. Check the Driven roller surface for contamination such as paper dust and CD-R coating. 3. Check the HP detection position of the CD-R tray for contamination or damage. 2. Pass plain paper of A3+ width from the ASF several times to remove contamination. 3. Change the CD-R tray for a new one. 1. Check the PW sensor for contamination such as paper dust. 1. Clean the PW sensor surface. Carriage unit bottom PW sensor 2. Compare the EEPROM 76 and BB values and check that 2. Change the PW sensor for a new one. they are not approximate to each other. TROUBLESHOOTING Troubleshooting 85