Epson 2200 Service Manual - Page 94
Table 3-15., Phenomenon-Based Cutter Position Error Check Points, Occurrence Timing, Phenomenon Detail
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
EPSON Stylus PHOTO 2100/2200 Revision B Occurrence Timing Phenomenon Detail At Cutter unit fitting (At power-on) At power-on, the Carriage produces operating sound instantaneously but the Paper LED indicates Blink 2 immediately. Table 3-15. Phenomenon-Based Cutter Position Error Check Points Faulty Part/Part Name Check Point Remedy Cutter motor 1. Check that the Cutter motor connector cable is connected to CN2 1. Connect the Cutter motor connector to CN2 on on the Driver board correctly. the Driver board securely. Cutter motor Driver board CN2 2. Check the Cutter motor for a failure. 3. Check the Cutter motor connector cable for damage. * Above 1 to 3 assume that the Cutter is not in the right HP position. At roll paper feeding After the roll paper is fed, the Cutter HP sensor 1. Check the Cutter HP sensor (right) and the rail groove of the by auto loading Cutter produces operating noise. (right) Cutter for paper dust, foreign matter, etc. Cutter HP sensor (right) CN4 2. Change the Cutter motor for a new one. 3. Change the Cutter motor for a new one. 1. Remove the paper dust, foreign matter, etc. from the Cutter HP sensor (right) and the rail groove of the Cutter. TROUBLESHOOTING 2. Check that the connector cable of the Cutter HP sensor (right) is connected securely. 3. Check the Cutter HP sensor (right) for damage. 2. Connect the connector cable of the Cutter HP sensor (right) to CN4 on the Driver board securely. 3. Change the Cutter HP sensor (right) for a new one. Troubleshooting 94