Epson BrightLink EB-760Wi Users Guide - Page 91

Setting Up Crestron Connected To set up your projector for monitoring and control using a Crestron Connected system, make sure your computer and projector are connected to the network. Note: If you want to use the Crestron Connected system when the projector is turned off, you need to adjust the Standby Mode setting in the Operation menu. The Standby Mode setting is displayed only if the A/V Output setting in the Signal I/O menu is set to While Projecting. 1. Press the Menu button. 2. Select the Network menu and press Enter. 3. Select Network Settings and press Enter. 4. Select the Projector Control menu and press Enter. 5. Set the Crestron Connected setting to On to allow the projector to be detected. Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson Projector Management software. To enable the Crestron XiO Cloud service, set Crestron XiO Cloud to On. 6. When you are finished selecting settings, select Return and press Enter to return to the Network Settings menu. 7. Select Set, and follow the on-screen instructions to save your settings and exit the menus. 8. Turn off the projector, then turn it on again to enable the setting. 9. Start your Web browser on a computer or device connected to the network. 10. Go to the Epson Web Control screen by entering the projector's IP address into the browser's address box. 11. Select the Crestron Connected settings. See the Crestron Web site for details. Parent topic: Using Crestron Connected Related references Network Settings - Network Menu Feature Settings - Operation Menu Input Signal Settings - Signal I/O Menu 91