Fluke 28IIEX Fluke 28IIEx User Manual - Page 44
How to Determine Pulse Width, HiRes Mode
View all Fluke 28IIEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
28 II Ex Users Manual How to Determine Pulse Width For a periodic waveform (its pattern repeats at equal time intervals), you can find the time that the signal is high or low as follows: 1. Measure the signal's frequency. 2. Push G a second time to measure the signal's duty cycle. Push E to select a measurement of the signal's positive or negative pulse, refer to Figure 9. 3. Use this formula to find the pulse width: Pulse Width (in seconds) = % Duty Cycle ÷ 100 Frequency HiRes Mode On the Product, push H for one second to enter the highresolution (HiRes) 4-1/2 digit mode. Measurements are shown at 10 times the usual resolution with a maximum display of 19,999 counts. The HiRes mode works in all modes but capacitance, frequency counter functions, temperature, and the 250 μs (peak) MIN MAX modes. To go to to the 3-1/2 digit mode, push H for one second. 34