Garmin aera 660 aera 660 Pilot s Guide - Page 150

Overview Navigation Appendix D NOTE: Readjust the position of the aera to provide the best view of the display screen as lighting conditions change. Attaching the yoke mount to the yoke shaft or control arm: 1) Open the clamp by turning the Clamp Adjustment Knob until it can be easily placed over the yoke shaft or control arm. Install the yoke mount as far from the panel as is practical. 2) When in place, tighten the Clamp Adjustment Knob to secure the yoke mount to the yoke shaft or control arm. 3) Loosen the Cradle Adjustment Knob, then orient the aera as desired. 4) Tighten the Cradle Adjustment Knob to hold the aera in place. 5) Connect power/data cables. Attaching the aera to the yoke mount: 1) Fit the bottom of the aera into the cradle. 2) Tilt the aera back until it snaps into place. Removing the aera from the yoke mount: 1) Press the Release Button on the side of the mount to release the aera. 2) Lift out the aera. Additional Features Hazard Avoidance Flight Planning Appendices Index 134 Garmin aera 660 Pilot's Guide 190-02017-20 Rev. A