HTC Hero Sprint HTC Sync Update for HERO (Sprint) (2.0.40) - Page 167

B. Regulatory Notices, Regulatory Agency Identifications - model number

Page 167 highlights

Regulatory Notices 4B. Regulatory Notices ࡗ Regulatory Agency Identifications (page 157) ࡗ Federal Communication Commission Interference Statement (page 157) ࡗ SAR Information (page 158) ࡗ Telecommunications & Internet Association (TIA) Safety Information (page 159) ࡗ WEEE Notice (page 159) ࡗ RoHS Compliance (page 159) This section provides more safety information and regulation statement for using your device. Regulatory Agency Identifications For regulatory identification purposes, your product is assigned a model number of HERO200. To ensure continued reliable and safe operation of your device, use only the accessories listed below with your HERO200. The Battery Pack has been assigned a model number of RHOD160. Operating temperature range: 32°F to 104°F (0°C to 40°C) Note This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1 Amp power supply unit. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ⅷ Reorient or relocate the receiving antenna. ⅷ Increase the separation between the equipment and receiver. ⅷ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ⅷ Consult the dealer or an experienced radio or television technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 4B. Regulatory Notices 157

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175

4B. Regulatory Notices
157
Regulatory Notices
±
Regulatory Agency Identifications (page 157)
±
Federal Communication Commission Interference Statement (page 157)
±
SAR Information (page 158)
±
Telecommunications & Internet Association (TIA) Safety Information (page 159)
±
WEEE Notice (page 159)
±
RoHS Compliance (page 159)
This section provides more safety information and regulation statement for using your device.
Regulatory Agency Identifications
For regulatory identification purposes, your product is assigned a model number of HERO200.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with
your HERO200.
The Battery Pack has been assigned a model number of RHOD160.
Operating temperature range: 32°F to 104°F (0°C to 40°C)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
³
Reorient or relocate the receiving antenna.
³
Increase the separation between the equipment and receiver.
³
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
³
Consult the dealer or an experienced radio or television technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
4B. Regulatory Notices
Note
This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1 Amp
power supply unit.