Haier AB122MCERA Operation Manual - Page 25
Ab092-482mcera
View all Haier AB122MCERA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Installation Procedures Preparation of Decorated Board • Don't put the decorated board downward to the floor. Putting it against the wall or on the extrusive objects is not allowed. • Don't touch the wind deflector or apply force on it, or the wind deflector will have faults. (1) Check if the indoor unit is in the horizontal level with the water level and the polythene tube with water and check if the size of the ceiling hole is correct. Take away the water level before mounting the decorated board. (2) Fasten the screw to make the height difference between two sides of the indoor unit less than 5mm. corner cover (3) Remove the inlet grid from the decorated board (refer to page 16). (4) Dismantle the cover on the corner: tear off the adhesive tape on the corner covers, and dismantle the covers after gliding. glide Installing the decorated board on the body of indoor unit: Di AB092-482MCERA 0 0 0 receiving window for remote control the lamp will not flash when wired controller is used (=, Limits when mounting the board: mount the board as shown in the figure. Incorrect direction may cause air leakage, and meanwhile the swinging and receiving displays can't be connected. (=D Position it with screws temporarily first. > Screw the two positioning screws and the other 2 screws and fasten them. > Connect it to the motor line, communication line and power line, and check with the controller if the connections are correct. Mount air inlet grid and corner covers after making sure that the machine can operate normally. 23