Haier AB122MCERA Operation Manual - Page 27
Haier AB122MCERA Manual
View all Haier AB122MCERA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation Procedures Attention Inappropriate tightening of screws might cause the faults as shown in Fig. 3. Tighten the screws properly. If there is still a gap between the decorated board and the ceiling after tightening the screws, please readjust the height of the body of the indoor unit. (Fig. 4) If the indoor unit keeps the horizontal level and the drainpipe can't be influenced, adjust the height of the body of the indoor unit from the holes on the corners of the decorated board. Fig.3 air leakage leakage from roof pollutio vapour condensate drops Any gap is not allowed Fig.4 c=, Wiring of Decorated Board a. Connect it to the connector of the wind deflector motor lead on the decorated board (Fig. 5); b. Connect it to the receiving terminal of remote controller on the decorated board. side of indoor unit I4. I4m*I I side of decorated board oo ./ electrical cabinet AB302-482MEERA (different from the actual condition) Fig.5 25