Haier AB122MCERA Operation Manual - Page 28
Haier AB122MCERA Manual
View all Haier AB122MCERA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Installation Procedures Mounting Air Inlet Grid and Corner Covers (1) Mounting the air inlet grid: Take care not to wind the lead of the wind deflector motor during mounting the air inlet grid. (2) For Model AB182-482MEERA units, the corner covers should be mounted on the corners. ©Tie the thread of the corner cover onto the cleat on the decorated board as shown in Fig. 6. ©Mount the corner cover onto the decorated board (as shown in Fig. 7). cleat 0 Slide the 5 locks to mount corner covers to fit the holes on decorated board a Fig.6 Fig.7 Attention • For proper drainage, the drainpipes should be connected according to the installation manual. Heat preservation should be performed as to prevent condensing. Improper connections may cause the \.. water leakage. _.) Requirements: • The drainpipe of the indoor unit should be heat-insulated. • Heat insulation should be treated for the connection with the indoor unit. Improper heat insulation may cause condensing. • The drainpipe with the down gradient of over 1/100 can't be in the S shape, or abnormal sound can be caused. • The horizon length of the drainpipe should be kept with 20m. Under the condition of long pipes, supports can be provided every 1.5-2m as to avoid unevenness. • The central piping should be connected according the following drawing. • Take care not to apply external force on the connection of the drainpipes. 1.5m-2m support bracket I I heat down gradient insulating over 1/100 material s-shape elbow x as big as possible (about 10 CM) =-)I I -Th I I vk down gradientVP30 0 over 1/100 26