HP 12000 HP 12200 Gateway Virtual Library System User Guide (BW403-10001, June - Page 103
Management, Changing the Account Passwords, Managing High Availability, Array Dual Pathing
View all HP 12000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
10 Management This section details the VLS management procedures such as changing the account passwords, managing high availability, and saving configuration settings. Changing the Account Passwords To change the administrator and/or user account password, from Command View VLS: 1. Click the System tab. 2. Select Chassis from the navigation tree. 3. Click Edit Accounts under Maintenance Tasks. The Edit Accounts window opens. 4. Enter the current password in the Old Password box. The password is case sensitive. 5. Enter a new password in the New Password box. 6. Enter the new password again in the Retype New Password box. 7. Click Apply Settings. Command View VLS restarts automatically. NOTE: You can change the user or administrator account password separately, or change both at the same time. NOTE: The password can also be changed from the VLS CLI. See "CLI Management commands" (page 143). Managing High Availability This section describes the methods to maintain high availability with your VLS. Array Dual Pathing The VLS system supports dual pathing to the arrays which provides path balancing and transparent path failover on the VLS. Having followed the setup recommendations in the HP StorageWorks VLS and D2D Solutions Guide and the installation instructions in this guide, each node on the VLS is connected to two fabrics/zones which are each connected to the arrays by two or more paths. This assures that the VLS can establish two paths per LUN, each path on a separate fabric/zone. Load Balancing For load balancing the VLS system, half of the data transfer (from a specific node through a fabric to the array) is conducted over one path; half over a second fabric, hence another path. The paths are selected as follows: Once configured, the device recognizes all paths to each node on the device. From all potential preferred paths and all potential secondary paths (see Step 3), the array assigns one preferred path and one secondary path. NOTE: During each reboot the device is re-analyzed and the preferred and secondary paths are reassigned. To view the preferred path for each LUN in the Storage LUN Details: 1. In Command View VLS, select the System tab. 2. Select Storage LUNs in the navigation tree. 3. Select the View button for either All LUNs or the LUNs in the desired . Summary information displays at the top of the list. Preferred and secondary paths are listed after the summary information in the Storage LUN Details Per Node sections. Changing the Account Passwords 103