HP 12000 HP 12200 Gateway Virtual Library System User Guide (BW403-10001, June - Page 37
Connecting a Destination Library to the VLS12200 Gateway
View all HP 12000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Using automigration, you can share a single destination library across multiple virtual libraries (maximum of 20 drives on the physical libraries), or configure multiple destination libraries to be used in a single virtual library. CAUTION: Automigration only supports destination libraries that have homogeneous drive types; for example, all drives are LTO-2. A mixture of drive types in the destination library, such as LTO-3 and LTO-2, is not supported. NOTE: Automigration allows you to use a VLS as a destination library. Because of this feature, it can also be used as a device-to-device local replication scheme. Connecting a Destination Library to the VLS12200 Gateway To connect the destination library to a Gateway device: 1. Connect your destination library to the VLS Gateway by connecting the library into the existing SAN zone that contains the arrays for this device. 2. Reboot the VLS. Upon reboot, the device detects the newly connected destination library. Managing and Unmanaging a Destination Library To manage a library is to enable automigration by connecting the source library to a destination library that is already on the VLS. Until you manage the destination library, it cannot communicate with the source. The process for managing destination libraries is different for SAN libraries than for LAN/WAN libraries. See "Managing a SAN Library" (page 37) or "Managing a LAN/WAN Replication Library" (page 37). An unmanaged library is a library that is not recognized by and using automigration or replication. The process for unmanaging destination libraries is the same for both SAN and LAN/WAN libraries. See "Unmanaging a SAN or LAN/WAN Library" (page 38). Managing a SAN Library To manage a SAN library: 1. Open the Automigration/Replication tab. 2. From the task bar, select Manage SAN Automigration Library. The screen displays all eligible libraries. Libraries that appear on the list but are greyed out either have no drives or have multiple drive types and therefore cannot be managed. Also, if there are no unmanaged drives, the system will return the message, "There are no unmanaged libraries." 3. If the library you wish to manage is not already selected, select it now. NOTE: You can only select one library to manage at a time. To manage additional libraries, repeat the procedure for each library to add. 4. Select Submit. The Destination Library Details screen displays, with the message, "The library, [library name], was managed successfully." You can now create pools for the library and manage your data on the library using automigration. You can also unmanage the library at any time. See "Unmanaging a SAN or LAN/WAN Library" (page 38) for instructions. Managing a LAN/WAN Replication Library To manage a LAN/WAN replication target: Managing and Unmanaging a Destination Library 37