HP 4400 HP StorageWorks Fabric OS 6.4.0c Release Notes (5697-0703, September 2 - Page 60
During reboot, HP StorageWorks D2D Backup System device sends
View all HP 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Closed defect summary Solution When an unsupported SFP is installed in an HP StorageWorks DC SAN Director Multiprotocol Extension Blade, the amber LED flashes to indicate a fault, as it should. However, if an optical cable is plugged into the SFP, the amber LED extinguishes. The actual port status is unchanged. Fixed in Fabric OS 6.4.0 When Lossless DLS is enabled, WebTools incorrectly shows iodset off, but the CLI shows that it is enabled. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Use CLI to view the configured IOD state when IOD is enabled with Lossless DLS. In a rare circumstance with a switch running Fabric Watch, a panic can occur after fwd terminated with exit code:134, exit sig:17, and parent sig:0 when IPC buffer is overrun on a busy system. Fixed in Fabric OS 6.4.0 With an HP StorageWorks 1606 SAN Extension Switch and an Multiprotocol Extension Blade, smart data for GE-type ports (such as SFP temperature and power) are not updated in sfpshow by the automatic polling loop. Fixed in Fabric OS 6.4.0 In a 2408 FCoE Switch and a 10/24 FCoE Blade, when CNA sends FIP ver=0, the switch should not validate the MAC descriptor field for backwards compatibility, but it does, leading to the switch rejecting the login. Fixed in Fabric OS 6.4.0 The host cannot recover if a back-end tape target becomes unresponsive Fixed in Fabric OS 6.4.0 during encryption switch-initiated commands. supportsave command does not capture information for FIDs with index Fixed in Fabric OS 6.4.0 greater than 3. Fabric Watch sometimes logs messages with values above 100%. Most Fixed in Fabric OS 6.4.0 likely occurs during first Fabric Watch polling cycle after slotstatsclear command is issued. Incorrect port shows I/O traffic on 2408 FCoE Switches and 10/24 Fixed in FCoE Blades. Fixed in Fabric OS 6.4.0 During reboot, HP StorageWorks D2D Backup System device sends the Fixed in Fabric OS 6.4.0 explicit logout; however, the switch does not clean up the route properly, resulting in the hosts being unable to detect the tape devices. In a rare case, a buffer leak in the rekey daemon causes an HP Storage- Fixed in Fabric OS 6.4.0 Works Encryption SAN Switch fault during rekey. A power cycle is required to recover. The SNMP manager gets incorrect MIB information from a switch running Fixed in Fabric OS 6.4.0 Fabric OS 6.1.x due to a change in SwFwEPortUtil and Sw- FwEPortPktl between SW_v5_7 to SW_v5_8 MIB. After upgrade from Fabric OS 6.2.x to Fabric OS 6.3.0b/c and then downgrade back down to Fabric OS6.2.0x, observe critical message "BKSW-5002 " swd_drv.c, line: 1323. Fixed in Fabric OS 6.4.0 The command fcoe loginshow displays unexpected values when an LP21000 or LP21002 CNA is moved between switches. Fixed in Fabric OS 6.4.0 60