HP 6125G HP 6125G & 6125G/XG Blade Switches IP Multicast Configuration - Page 329

Configuring IPv6 PIM common timers on an interface Step 1. Enter system view. 2. Enter interface view. Command system-view interface interface-type interface-number 3. Configure the hello interval. pim ipv6 timer hello interval 4. Configure the maximum delay pim ipv6 triggered-hello-delay between hello messages. interval 5. Configure the join/prune interval. pim ipv6 timer join-prune interval 6. Configure the join/prune timeout time. pim ipv6 holdtime join-prune interval 7. Configure assert timeout time. pim ipv6 holdtime assert interval Remarks N/A N/A Optional. 30 seconds by default. Optional. 5 seconds by default. Optional. 60 seconds by default. Optional. 210 seconds by default. Optional 180 seconds by default. Configuring join/prune message sizes A large size of a join/prune message might result in loss of a larger amount of information if a message is lost. You can set a small value for the size of each join/prune message to reduce the impact in case of the loss of a message. By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively reduce the number of (S, G) entries sent per unit of time. IMPORTANT: If IPv6 PIM snooping-enabled switches are deployed in the IPv6 PIM network, be sure to set a value no greater than the IPv6 path MTU for the maximum size of each join/prune message on the receiver-side edge IPv6 PIM devices. To configure join/prune message sizes: Step 1. Enter system view. Command system-view 2. Enter IPv6 PIM view. pim ipv6 3. Configure the maximum size of each join/prune message. jp-pkt-size packet-size 4. Configure the maximum number of (S, G) entries in a join/prune message. jp-queue-size queue-size Remarks N/A N/A Optional. 8100 bytes by default. Optional. 1020 by default. 318