HP 8/40 Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010) - Page 613

90 SEC-1164 Probable Cause Indicates the lockdown option was attempted while the fabric is already in secure mode. Recommended Do not use lockdown option with the secModeEnable command when a switch is already in secure Action mode. Severity ERROR SEC-1164 Message , [SEC-1164], ,, ERROR, , Lockdown option cannot be applied on a non-FCS switch. Probable Cause Indicates the attempt to enable security is made on a switch that is not present in the fabric configuration server (FCS) list. Recommended Add the switch to the FCS policy list when using the lockdown option to enable security. Action Severity ERROR SEC-1165 Message , [SEC-1165], ,, ERROR, , Low memory, failed to enable security on all switches. Probable Cause Indicates the system is low on memory. Recommended Wait a few minutes and try the command again. Action Severity ERROR SEC-1166 Message , [SEC-1166], ,, ERROR, , Non FCS tries to commit failover. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR Fabric OS Message Reference 537 53-1001767-01