HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 114

action syslog Chapter 2 A Commands Send documentation comments to [email protected] action syslog To configure a syslog message to generate when an Embedded Event Manager (EEM) applet is triggered, use the action syslog command. To disable the syslog message, use the no form of this command. action number[.number2] syslog [priority prio-val] msg error-message no action number[.number2] syslog [priority prio-val] msg error-message Syntax Description number.number2 priority prio-val msg error message Number can be any number up to 16 digits. The range for number2 is from 0 to 9. (Optional) Specifies the priority level of the syslog messages. If this keyword is not selected, all syslog messages are set at the informational priority level. If this keyword is selected, the priority level argument must be defined. There are three ways of defining the priority level: • Define the priority level using one of these methods: - 0-System is unusable. - 1-Immediate action is needed. - 2-Critical conditions. - 3-Error conditions. - 4-Warning conditions. - 5-Normal but significant conditions. - 6-Informational messages. This is the default. - 7-Debugging messages. • Enter the priority by selecting one of the priority keywords: -emergencies-System is unusable. - alerts-Immediate action is needed. - critical-Critical conditions. - errors-Error conditions. - warnings-Warning conditions. - notifications-Normal but significant conditions. - informational-Informational messages. This is the default. - debugging-Debugging messages. Specifies the error message. The message can be any quoted alphanumeric string up to 80 characters. Defaults None. Command Modes Embedded Event Manager mode. 2-22 Cisco MDS 9000 Family Command Reference OL-18089-02, Cisco MDS NX-OS Release 4.x