HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 376

debug ethport Chapter 6 Debug Commands Send documentation comments to [email protected] debug ethport To enable Ethernet port debugging, use the debug ethport command in EXEC mode. To disable a debug command, use the no form of the command or use the no debug all command to turn off all debugging. debug ethport {all | error | event [interface gigabitethernet slot/port | module slot] | ha [interface gigibetethernet slot/port | module slot] | trace [interface gigibetethernet slot/port | module slot]} no debug ethport {all | error | event [interface gigabitethernet slot/port | module slot] | ha [interface gigibetethernet slot/port | module slot] | trace [interface gigibetethernet slot/port | module slot]} Syntax Description all error event ha trace interface gigibetethernet slot/port module slot Enables debugging for all Ethernet port features. Enables debugging for Ethernet port error conditions. Enables debugging for Ethernet port events. Enables debugging for port high availability. Enables debugging for Ethernet port traces. Specifies the slot and port of the Gigabit Ethernet interface. (Optional) Specifies the slot number of the module being debugged. Defaults Disabled. Command Modes EXEC mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines None. Examples The following example displays the system output when the debug ethport all command is issued: switch# debug ethport all 1981 May 5 07:28:59 ethport: fu_fsm_execute_all: match_msg_id(0), log_already_open(0) 1981 May 5 07:28:59 ethport: fu_fsm_execute_all: null fsm_event_list 1981 May 5 07:28:59 ethport: fu_fsm_engine_post_event_processing: mts msg MTS_OPC_DEBUG_WRAP_MSG(msg_id 52343) dropped Related Commands 6-26 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x