HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 962

server (DMM job configuration submode) Chapter 21 S Commands Send documentation comments to [email protected] server (DMM job configuration submode) To add a server HBA port to the DMM job, use the server command in DMM job configuration submode. To remove the server HBA port, use the no form of the command. server vsan vsan-id pwwn port-wwn no server vsan vsan-id pwwn port-wwn Syntax Description vsan vsan-id pwwn port-wwn Specifies the VSAN ID. The range is 1 to 4093. Specifies the port worldwide name of the server HBA port. The format is hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number. Defaults None. Command Modes DMM job configuration submode. Command History Release 3.2(1) Modification This command was introduced. Usage Guidelines None. Examples The following example shows how to add server information to a DMM job: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# dmm module 3 job 1 create Started New DMM Job Configuration. Do not exit sub-mode until configuration is complete and committed switch(config-dmm-job)# server vsan 3 pwwn 1d:22:3a:21:3c:44:3b:51 switch(config-dmm-job)# Related Commands Command show dmm ip-peer show dmm srvr-vt-login Description Displays job information. Displays server VT login information. 21-24 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x