HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 1176

show fc-redirect peer-switches Chapter 22 Show Commands Send documentation comments to [email protected] show fc-redirect peer-switches To display all the peer switches in the fabric running FC-Redirect, use the show fc-redirect peer-switches command. show fc-redirect peer-switches Syntax Description This command has no arguments or keywords. Defaults None. Command Modes EXEC mode Command History Release 3.2(1) 3.3(1a) Modification This command was introduced. Added the FC-Redirect version of the switch and configuration mode to the command output. Usage Guidelines This command is used to verify the fabric state and is used for troubleshooting. Note To find the switch IP address for the list of switch WWNs, use the show cfs peers command. Examples The following example displays the peer switches in the fabric running FC-Redirect switch# show fc-redirect peer-switches num Switch WWN State FCR-Ver Cfg-Mode 1 20:00:00:0d:EC:20:13:00 UP 2 V2 Table 22-3 describes the output for the show fc-redirect peer-switches states. Table 22-3 Show FC-Redirect Peer Switch States State Up Down Syncing Error Description The peer switch is fully synchronized with the local switch. The communication with the peer switch is not available. The local switch is synchronizing its configuration with the peer switch. Connection with peer switch is not available. 22-108 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x