HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 851

Chapter 18 P Commands port-monitor name Send documentation comments to [email protected] port-monitor name To display the counter details of the policy, use the port-monitor name command. To delete port monitor policy, use the no form of the command. port-monitor name [string] no port-monitor name [string] Syntax Description string Displays the policy name. Defaults None. Command Modes Configuration mode. Command History Release 4.1(1b) Modification This command was introduced. Usage Guidelines None. Examples The following example shows how to create a cisco policy name and to assign the default value: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# port-monitor name cisco switch(config-port-monitor)# switch(config-port-monitor)# do show port-monitor cisco Policy Name : cisco Status : Not Active Port type : All Ports Counter Threshold Interval Rising Threshold Falling Threshold Stat Link Loss Delta 60 5 1 Active Sync Loss Delta 60 5 1 Active Protocol Error Delta 60 1 0 Active Signal Loss Delta 60 5 1 Active Invalid Words Delta 60 1 0 Active Invalid CRC's Delta 60 5 1 Active RX Performance Delta 60 2147483648 524288000 Active TX Performance Delta 60 2147483648 524288000 Active State Change Delta 60 1 0 Active switch(config-port-monitor)# Related Commands Command show port-monitor Description Displays all port monitor policies. OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 18-19