HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 1349

Chapter 22 Show Commands show module Send documentation comments to [email protected] show module To verify the status of a module, use the show module command. show module [slot [recovery-steps] | diag | uptime | xbar number] Syntax Description slot recovery-steps diag uptime xbar number Specifies the slot number for the module. Displays information about modules and the steps to recover a module. Displays module-related information. Displays the length of time that the modules have been functional in the switch. Displays information about the specified crossbar, either 1 or 2. Defaults None. Command Modes EXEC mode. Command History Release 1.3(4) 3.0(1) NX-OS 4.1(1b) NX-OS 4.1(1b) NX-OS 4.1(1b) NX-OS 4.1(1b) NX-OS 4.1(1b) Modification This command was introduced. Added the recovery-steps and xbar options. Added the command output for a module resource on a 24 port line card with all ports in shared mode. Added the command output for a module resource on a 24 port line card with few ports in shared mode and few port in dedicated mode. Added the command output for a module resource on a 12 port line card with all ports in dedicated mode. Added the command output for a module resource on a 12 port line card with all ports in dedicated mode and extended feature enabled. Added the command output for show module xbar. Usage Guidelines If your chassis has more than one switching module, you will see the progress check if you issue the show module command several times and view the status column each time. The switching module goes through a testing and an initializing stage before displaying an ok status. Use the uptime option to display the time that a specified supervisor module, switching module, or services module is functional in the switch. This time is computed from the time a module goes online after a disruptive upgrade or reset. You can use the recovery-steps option only for modules that are powered down because of problems with index allocation. Before using the recovery-steps option, make sure that debug module no-power-down is not on. OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 22-281