HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide - R - Page 1036

Using the FCIP Wizard Chapter 48 Configuring FCIP Send documentation comments to [email protected] Step 6 Step 7 Step 8 Step 9 Modify the optional TCP parameters, if desired. Refer to Fabric Manager Online Help for explanations of these fields. (Optional) Click the Tunnels tab and modify the remote IP address in the Remote IPAddress field for the endpoint to which you want to link. Enter the optional parameters, if desired. See the Cisco MDS 9000 Family CLI Configuration Guide for information on displaying FCIP profile information. Click Apply Changes icon to save these changes. Creating FCIP Links When two FCIP link endpoints are created, an FCIP link is established between the two IPS modules or MPS-14/2 modules. To create an FCIP link, assign a profile to the FCIP interface and configure the peer information. The peer IP switch information initiates (creates) an FCIP link to that peer switch (see Figure 48-19). Figure 48-19 Assigning Profiles to Each Gigabit Ethernet Interface Endpoint Interface FCIP = 51 Profile = 10 Connecting switch (peer) = 10.1.1.1 Switch 1 Endpoint Interface FCIP = 52 Profile = 20 Connecting switch (peer) = 10.100.1.25 Switch 2 FCIP link Virtual (E) ISL Switch 1 IP router IP address of Gigabit Ethernet interface 3/1 = 10.100.1.25 IP network IP router Switch 2 IP address of Gigabit Ethernet interface 3/1 = 10.1.1.1 91562 Verifying Interfaces and Extended Link Protocol To verify the FCIP interfaces and Extended Link Protocol (ELP) on Device Manager, follow these steps: Step 1 Step 2 Step 3 Make sure you are connected to a switch that contains an IPS module. Select FCIP from the Interface menu. Click the Interfaces tab if it is not already selected. You see the FCIP Interfaces dialog box. 48-16 Cisco MDS 9000 Family Fabric Manager Configuration Guide OL-17256-03, Cisco MDS NX-OS Release 4.x