HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide - R - Page 418

Fibre Channel Interfaces Chapter 20 Configuring Interfaces Send documentation comments to [email protected] Table 20-1 Administrative States Administrative State Up Down Description Interface is enabled. Interface is disabled. If you administratively disable an interface by shutting down that interface, the physical link layer state change is ignored. Operational States The operational state indicates the current operational state of the interface as described in Table 20-2. Table 20-2 Operational States Operational State Up Down Trunking Description Interface is transmitting or receiving traffic as desired. To be in this state, an interface must be administratively up, the interface link layer state must be up, and the interface initialization must be completed. Interface cannot transmit or receive (data) traffic. Interface is operational in TE or TF mode. Reason Codes Reason codes are dependent on the operational state of the interface as described in Table 20-3. Table 20-3 Reason Codes for Interface States Administrative Configuration Up Down Up Operational Status Up Down Down Reason Code None. Administratively down-If you administratively configure an interface as down, you disable the interface. No traffic is received or transmitted. See Table 20-4. Note Only some of the reason codes are listed in Table 20-4. If the administrative state is up and the operational state is down, the reason code differs based on the nonoperational reason code as described in Table 20-4. 20-8 Cisco MDS 9000 Family Fabric Manager Configuration Guide OL-17256-03, Cisco MDS NX-OS Release 4.x