HP Cisco MDS 9124 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 101

Chapter 2 A Commands aaa group server Send documentation comments to [email protected] aaa group server To configure one or more independent server groups, use the aaa group server command in configuration mode. To remove the server group, use the no form of this command to remove the server group. aaa group server {radius | tacacs+} group-name server server-name no server server-name no aaa group server {radius | tacacs+} group-name server server-name no server server-name Syntax Description radius tacacs+ group-name server server-name Specifies the RADIUS server group. Specifies the TACACS+ server group. Identifies the specified group of servers with a user-defined name. The name is limited to 64 alphanumeric characters. Specifies the server name to add or remove from the server group. Defaults None. Command Modes Configuration. Command History Release 1.3(1) Modification This command was introduced. Usage Guidelines You can configure these server groups at any time but they only take effect when you apply them to a AAA service using the aaa authentication login or the aaa accounting commands. Examples The follwoing example shows how you can configure these server groups at any time but they only take effect when you apply them to a AAA service using the aaa authentication or the aaa accounting commands: switch# config terminal switch(config)# aaa group server tacacs+ TacacsServer1 switch(config-tacacs+)# server ServerA switch(config-tacacs+)# exit switch(config)# aaa group server radius RadiusServer19 switch(config-radius)# server ServerB switch(config-radius)# no server ServerZ OL-18089-02, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 2-9