HP Cisco MDS 9124 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 262

counter Chapter 4 C Commands Send documentation comments to [email protected] counter To configure an indivisual counter to override the default configuration, use the counter command. To reset the value of the counter to default value, use the no form of the command. counter{link-loss | sync-loss | invalid-crc | invalid-words | protocol-error | rx-performance | tx-performance | state-change} poll-interval interval {absolute | delta} rising-threshold rising threshold event event id falling-threshold low threshold event event id Syntax Description link loss sync-loss invalid-crc invalid-words protocol-errors rx-performance tx-performance state-change poll-interval interval absolute/delta rising-threshold rising-threshold event event-id falling-threshold low-threshold Configures link loss counter. Configures sync loss counter. Configures invalid CRC counter. Configures invalid words counter. Configures protocol error counter. Counfigures RX performance counter. Configures TX performance counter. Configures state-change counter. Configures poll interval for counter. Displays poll interval in seconds. Displays the threshold type. Configures the upper threshold value. Sets numerical upper threshold limit. Configures high threshold event. Displays event ID from event configuration. Configures the lower threshold value. Sets numerical low threshold limit. Defaults None. Command Modes Configuration submode. Command History Release 4.1(1b) Modification This command was introduced. Usage Guidelines This command shows each threshold per interface and the threshold values inherited from the policies. Note The falling threshold and the event need not be configured and are optional. The no counter command will reset the value of the counter to the default value. 4-122 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x