HP Cisco MDS 9124 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 664

ips netsim delay-ms Chapter 11 I Commands Send documentation comments to [email protected] ips netsim delay-ms To delay packets that arrive at a specified Gigabit Ethernet interface specifying milliseconds, use the ips netsim delay command in SAN extension tuner configuration submode. ips netsim delay-ms milliseconds ingress gigabitethernet slot/port Syntax Description delay-ms milliseconds ingress gigabitethernet slot/port Specifies the delay in milliseconds. The range is 0 to 150. Specifies the ingress direction. Specifies the the slot and port number of the Gigabit Ethernet interface. Defaults Disabled. Command Modes SAN extension tuner configuration submode. Command History Release 3.1(1) Modification This command was introduced. Usage Guidelines To use this command, you must enable the IP Network Simulator using the ips netsim enable command. This command introduces a delay for all packets entering the Gigabit Ethernet interface. Delay is unidirectional. To introduce delay in the opposite direction, use the slot and port number of the adjacent interface. Examples The following example shows how to configure a delay of 50 milliseconds for packets entering Gigabit Ethernet interface 2/3: switch# config terminal switch(config)# switch(config)# san-ext-tuner enable switch(config)# exit switch# switch# ips netsim delay-ms 50 ingress gigabitethernet 2/3 Related Commands Command show ips netsim ips netsim enable Description Displays a summary of the interfaces that are currently operating in network simulation mode. Enables the IP Network Simulator. 11-58 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x