HP Color LaserJet Enterprise CM4540 Service Manual - Page 697

Send-fax messages Table 3-38 Send-fax messages Message Error No. Cancelled 0 Success n/a Fail Busy 0 No Answer 0 Compression Error Any No Dial 0 Modem Fail Any Communication Error 17 or 36 Communication Error Any besides 17 or 36 Space Fail 0 Page Fail 0 Memory Error 0 Job Fail Any Description Action(s) Fax was cancelled by user at None. control panel of product. Fax sent successfully. None. The receiving fax machine is busy. The fax will be retired automatically (if configured), otherwise try resending fax later. The receiving fax machine is not answering the call. The receiving fax machine may be disconnected or turned off; contact the receiver to check the machine. Try resending. Fax may be corrupted or not Try resending fax. sent. No dial tone is detected when sending the fax. Verify the phone line is active; set the sending fax to "not" to detect a dial tone. Unexpected or bad response from the internal fax modem to product. Try resending fax; if the error persists, contact service. NOTE: This does not necessarily indicate that the modem hardware is bad. Lost telephone connection between sender and receiver. May be due to voice calls. Try resending the fax. General communications issue where the fax transmission was interrupted or did not proceed as expected. Try resending fax; if the error persists, contact service. Unable to read or write the fax image file to disk; could be corrupt product disk or no space available on the product's disk. Try resending fax; if the error persists, contact service. Incompatible page width, or page had too many bad lines. Try resending fax; if the error persists, contact service. Out of RAM memory on product. If error persists, may need to add RAM to product. Fax failure; the fax job did not complete. Try resending fax; if the error persists, contact service. ENWW Solve fax problems 645