HP LaserJet Pro 300 Service Manual - Page 102
Fuser motor assembly, Remove the fuser motor assembly
View all HP LaserJet Pro 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Fuser motor assembly Before proceeding, remove the following components: ● Right cover. See Right cover on page 21. ● Formatter PCA. See Formatter PCA on page 74. ● Rear-upper cover (duplex products). See Rear-upper cover (duplex product) on page 24. ● Rear door (simplex products). See Rear door (simplex product) on page 26. ● Rear cover (simplex products). See Rear cover and feed guide (simplex product) on page 30. ● Upper-cover assembly. See Upper-cover assembly on page 41. ● Control-panel assembly. See Control-panel assembly on page 50. ● Right panel. See Right panel on page 52. Remove the fuser motor assembly 1. Remove four flat-head screws (callout 1), three screws (callout 2), and then remove the sheet-metal plate. CAUTION: The four flat-head screws must be installed in the correct position to avoid damage to the formatter. Standard screws can contact the formatter when it is installed and can cause a formatter short circuit. Figure 1-111 Remove the fuser motor assembly (1 of 4) 1 2 78 Chapter 1 Removal and replacement ENWW