HP Neoware c50 TeemTalk® 5.0 for Windows CE & XPe User's Guide - Page 127

Wyse Settings Setup Menus This dialog box is displayed by selecting Wyse in the Settings menu. Note that some of the settings apply to the TVI 910+, TVI 920, TVI 925, ADDS A2 and HZ 1500 emulations in addition to the Wyse emulations. Also, some settings may not apply to the particular Wyse emulation currently running. Selecting a setting that is not applicable to the current emulation will cause the emulator to use the default setting for that emulation when the dialog box is exited. Note: The Tab Stops dialog box displayed by clicking the Set Tabs button is described later in this chapter, after the Terminal Settings description. Lines Factory default: 24 This option applies to the WY-50+ and WY-60 emulations and specifies the number of data lines displayed on the screen below the status line. Note that the other emulations only support 24 lines and a label line. 24 24 data lines and a label line at the bottom. 25 25 data lines but no label line. 42 42 data lines and a label line at the bottom. 43 43 data lines but no label line. 6-43