HP StorageWorks 2/16V HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 10
Installing the Outer Rails (HP 10000 Series Racks), tighten the hex nuts later
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
4. Assemble the outer rails by completing the following steps: a. Attach the left outer rail and the right outer rails to the rear mounting brackets using two 1/4-20 hex nuts with captive star lock washers. Attach the hex nuts loosely (as shown in Figure 3). Do not tighten; tighten the hex nuts later in step 3 on page 19. Figure 3: Installing the Outer Rails (HP 10000 Series Racks) 10 SAN Switch rack mount kit installation instructions
10
SAN Switch rack mount kit installation instructions
4.
Assemble the outer rails by completing the following steps:
a.
Attach the left outer rail and the right outer rails to the rear mounting
brackets using two 1/4-20 hex nuts with captive star lock washers.
Attach the hex nuts loosely (as shown in
Figure 3
). Do not tighten;
tighten the hex nuts later in
step 3
on page 19.
Figure 3:
Installing the Outer Rails (HP 10000 Series Racks)