HP StorageWorks 2/16V HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 13

13

SAN Switch rack mount kit installation instructions

5.

Depending on the device model, the SAN Switch Rack Mount Kit

requires different screw types for securing the inner rails. Use

Table 2

to

determine the number and screw type for your specific switch or MP

Router model.

Caution:

Do not use any other screws other than the ones provided in the

kit. Use of longer screws may cause damage to internal components.

6.

Identify the screw holes on the inner rails designed for your specific

device as follows:

a.

To attach the inner rails to the SAN Switch 2/16, SAN Switch 2/8V,

or SAN Switch 2/16V use the screw holes marked

8.

b.

To attach the inner rails to the 4/8 and 4/16 SAN Switches, use the

screw holes marked

8

.

Table 2:

Number of Screws Required to Secure the Inner Rails

Device Model

#8-32 x .312 Phillips

Pan-head SEMs Screws

#8-32 x 3/16-inch

Screws

SAN Switch 2/16,

SAN Switch 2/8V, or

SAN Switch 2/16V

Ten (Five per rail)

N/A

SAN Switch 2/32

N/A

12 (Six per rail)

MP Router

Six (Three per rail)

N/A

SAN Switch 4/32

Ten (Five per rail)

N/A

4/8 and 4/16 SAN

Switch

Ten (Five per rail)

N/A

4/64 SAN Switch

and

400 MP Router switch

Ten (Five per rail)

N/A

4/32B SAN Switch

Six (Three per rail)

N/A

Section	Page
About this Document	3
Supported Devices	3
Supported HP Custom Racks	3
Related Documentation	4
Before You Begin - Important Information about the Plenum	4
Installation and Safety Guidelines	5
Using the SAN Switch Rack Mount Kit to Install an HP StorageWorks Device	6
Required Tools and Hardware	6
Table 1: Hardware included in the SAN Switch Rack Mount Kit	6
Figure 1: Installing the Rear Mounting Brackets (HP 10000 Series Racks)	8
Figure 2: Installing the Rear Mounting Brackets (HP System/e Rack)	9
Figure 3: Installing the Outer Rails (HP 10000 Series Racks)	10
Figure 4: Assembling the Outer Rails (HP 10000 Series Racks)	11
Figure 5: Assembling the Outer Rails (HP System/e Rack)	12
Table 2: Number of Screws Required to Secure the Inner Rails	13
Figure 6: Attaching the Inner Rails to an MP Router	15
Figure 7: Attaching the Inner Rails to a 4/64 SAN Switch	15
Installing the Plenum (if required)	17
Figure 8: Attaching the Plenum to a 4/8 or 4/16 SAN Switch	17
Securing the Device to the Outer Rails	18
Figure 9: Securing the Device (in HP 9000 Series or HP 10000 Series Racks)	18

HP StorageWorks 2/16V HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 13

Table 2: Number of Screws Required to Secure the Inner Rails

Page 13 highlights