HP StorageWorks 2/16V HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 6
Using the SAN Switch Rack Mount Kit to Install an HP StorageWorks Device, Required Tools and Hardware
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Using the SAN Switch Rack Mount Kit to Install an HP StorageWorks Device Read this section to install a SAN Switch or MP Router in an HP 9000 Series, HP 10000 Series, HP 10000 G2 Series or HP System/e rack. Note: The SAN Switch Rack Mount Kit installation requires one technician. Required Tools and Hardware Obtain the following items: ■ #2 Phillips screwdriver ■ 7/16-inch wrench or socket ■ HP StorageWorks device, see Supported Devices on page 3 ■ Plenum (if required), see Before You Begin - Important Information about the Plenum, page 4 ■ Power cables ■ SAN Switch Rack Mount Kit hardware (smaller items like screws ship in plastic bags in the kit), see Table 1 Table 1: Hardware included in the SAN Switch Rack Mount Kit Item Description Two (2) rear mounting brackets A right inner rail and a right outer rail A left inner rail and a left outer rail 6 SAN Switch rack mount kit installation instructions